Bapmic 24152333907 6HP19 Transmission Oil Pan with Gasket Screw Repair Kit for BMW

Install it’s about eight months ago worst grade looks so very good quality so I’m happy with the way it turned out

This 6HP19 transmission oil pan fit my BMW 2007 525i perfectly. Thanks so much !!!

I think everything included in the kits works very well with the exception of the supplied pan bolts. I broke the heads off of three! I'm very experienced, have great tools and lots of patients so 3 failures out of 20 is poor. My technique was to just us a 1/4" extension with the torx bit on and finger tighten bolts in the correct pattern. Next snug them with 2 fingers on a 1/4" ratchet in the correct pattern. I then used a nice 1/4" inch pound torgue wrench set to 40 inch pounds, less than half of the torgue spec, and had one failure. Next I went to the exact torgue spec and had 2 more failures. All three bolts failed in the same way. The head separated from the stud leaving the bolt head hollow. I was able to get a small flat blade screwdriver on them and get them to back out very easily. I replaced them with the bolts I took out and they tightened up just fine. I drove the car for 5 days (about 250 miles) checked the pan for leaks. NONE! I rechecked the torgue on the pan bolts and they were all fine and no more breaks. I then compared the depth of the torx cavity on the failed bolts to several that held and found about 2 mm more depth on the failed ones. More depth means less material common between the stud and bolt head and thus less strength. The BMW OEM bolts are stainless steel versus the plated bolts in this kit. I kept all my OEM bolts and If I ever do this again I'll put them all back in. I STILL RECOMMEND this product since everything else worked well and no leaks.

Didn’t have any issues installing and after 2,000 miles no leaks. Didn’t use the included bolts and just reused the old ones.

Works well

Muy util y buena calidad

Perfect fit on my 2005 BMW 325i

Perfect fit, great price.

bolts are cheap and snapped off as I was hand tightening - I did not even get the chance to torque them to factory specs - I had to re-use the old bolts

Great product. Worth the money. Worked on my 2008 BMW 335xi