AMI PARTS WR51X10055 Refrigerator Defrost Heater Kit,Temperature Sensor WR55X10025,High Limit Thermostat WR50X10068 Replacement for General Electric

It works and it fits the older GE profile fridge, with the exception the sensor and switch (that black round thang) needs to be cut and spliced in. So make sure you have small zip tie, smaller electrical butt connectors (or soldering iron) and some heat shrink also. If you are diy this. For me the bracket that is holding the sliding baskets/shelfs needs to come off for the cover panel to come out they are held in place with T15 screws. And 4x 1/4 hex head sheet metal screw for the panel.

Great product, but make sure you install all three parts at the same time to make sure each part is compatible. It's been approximately 6 months and freezer/ fridge is working great.

Good fit, works perfect.Ended up only needing the heater but it was nice to have all the parts on hand just in case.

The coil sensor with the Orange and Pink wired I used and the heating coil.The white sensor requires you to splice it in the blower motor harness. I didn't feel comfortable splicing it, so I bought the blower motor and it comes with the wiring harness and the white sensor attached. It worked fabulously.Under a $100.00 and I had the refrigerator back working. That was about $200.00 less than what an appliance repair technician would have charged us.

This is the FOURTH time I have replaced the heater. Regardless of brand (first time in 2018 I bought "genuine GE"), they only seem to last 2 years. Fortunately cheap and easy to replace.

Installed this June 2024. Dead today. Only about 7 months until we recognized that we were not circulating cold air. Instead of $17, I will buy the $90+ unit. Sometimes, you really do get what you pay for. Please see pics and what you are recommended to avoid.

Excelente producto y calidad

Just what my fridge needed and much cheaper than getting it from the parts supply store