Gaahing Flexible Crown Molding | Peel and Stick Self-Adhesive Design | Wall Trim for Cabinet Mirror Frame Home Decor, 16.4 ft x 1.4 inch

As pictured, but the inside is white so when I cut it I just used black paint to hide the little seems where needed and it looks fineEasy to install BUT I used construction adhesive instead of the sticky backing it comes withStill worth it in my opinionEasy to cut but thick and pretty

I've been wanting to frame out my large bathroom mirror for years now, but couldn't afford the real frame kits and don't know anyone handy enough to help me cut actual moulding and attach it for me. I bought this self adhesive vinyl but honestly didn't have much hope for it working well. It did work though; I was pleasantly surprised. Like many, I had to caulk the corners, but had I cut the corners with an exact knife and not scissors I think it would have worked better. I traced the 45 degree angle needed from an old piece of cut moulding, but the scissors didn't cut perfectly and created a messy edge. The caulk helped though. DO cut the corners at 45 degrees though, don't just butt the edges up against each other like the photos in the official description show (I am surprised the official pictures show the wrong way to do it). The vinyl is HEAVY and CUMBERSOME so it's hard to handle on your own. If you can get someone to help hold it up and keep it straight while you measure (it's thick and wants to curl) you'll be better off and likely achieve better results. It sticks very well and we have three girls here who take long, hot showers. This has shown no detachment from the mirror at all. I kind of wish I had purchased the design that is actually sold as mirror frame as I think it might look nicer than this one (same company, different frame option) but it's too late now. I think this one might be a little too much, whereas the mirror frame is thinner and less ostentatious. But don't get me wrong, this looks very nice and is a HUGE improvement over the plain mirror and it also covers up some damage along the edge of the mirror. I would recommend this, but again, cut 45 degree angles and have help.

I love love love this framing tape. I just redid my apartment bathroom that has a large unframed mirror that looked out of place when I was redoing the bathroom and this was the perfect solution. It’s super easy to use and I was able to cut through it with normal scissors so no special tools are required and one roll was more than enough to do the whole mirror. It does bump out a bit where the mirror hangers are (pictured) which is to be expected if your mirror has those. The only reason I gave it 4 stars is because I’m not sure how well it will hold up. I had to readjust one piece a few times and one piece fell down so you really have to stick it properly the first time to avoid that. I have also noticed a couple corners sliding or unsticking so hopefully they stay up

The media could not be loaded. I bought this mirror border to do a cheap bathroom remodel in our new home. It took me about 25 minutes total. This was for a small, half bathroom mirror. I only ordered one. If you are going to do a larger, normal bathroom mirror, definitely order two.Some tips below. I hope this helps someone.1. Measure the pieces across the mirror, end to end. Cut them (leave all plastic on).2. Clean your mirror and be sure it is completely dry.3. I left parts of the red backing tape on the corners so I could stick the rest of it on without the ends sticking to the mirror. I then put them on the mirror and left the red tape end over laying on eachother on the end. Then, when I was ready to stick the ends, I measured and made cuts shorter and shorter until it was matching up. I then pulled the red backing off to seal the ends to the mirror.BE SURE TO STICK THE PATERNS MATCHING RIGHT SIDE UP. The design almost looks the same, but if you turn it upside down, you will notice because there is a small difference.

These are quite beautiful, and the quality is nice and heavy and they give you a decent amount. I was surprised when they arrived with how heavy they are. I only suggest maybe using a couple tiny white nails to help hold it up or a stronger adhesive just to be sure it stays up and sticks. Beautiful pattern.

I am having trouble cutting the corners to meet up. Could be my skill set. Still haven't finished my intended project.

I bought the white with silver, I really didn't want silver, but the plain white was out of stock and I was planning to paint it anyway. I was quite impressed with this, it was so easy to work with and with using a blow dryer, I was able to go around the corner of my desk. I painted it, glazed it so it gave it an antique look and I'm very happy with it. I'm looking for other places to use it!

This border has a beautiful rich design. I was a little confused when I ordered it because of the way it showed up on the ordering page. The black on is listed by m and mm in measurement. It should be the same way the others are listed because it would make it easier for buyers. It took me some time searching, but I did find all sizes of colors to be the same. The border was shipped super fast. The installation was easy because my husband did it. He is a perfectionist. I am a hack. All in all, I loved this border.